The patch technology in nail art includes full patch, half patch, and shallow patch. The process of making patch nails is different, the method of operation is different, and the way of patching is different, so you should pay attention and distinguish when operating.
1. The operation steps of pasting a shallow patch are exactly the same as pasting a half patch, except that the groove of the shallow patch covers the front edge of the nail, while the groove of the half patch covers one third of the nail. . Before attaching the patch, be sure to clean the dirt after the natural nail is carved. If it is not cleaned and left with dust, such a nail surface will enter the air due to non-compliance after the patch is attached, and generate bubbles.
2. Generally, a layer of crystal powder or gel needs to be placed behind the patch for general shallow patches. It is best to use special glue for nail patch, which is colloidal rather than water-based, has low fluidity and is not easy to produce bubbles, and is easier to operate.
3. The use of shallow patches without grooves can prevent the patch glue from flowing into the finger core. The nail piece should be glued on the natural nail area and spread evenly. If it is not evenly, it will cause a vacuum after the application is completed, which is the bubble seen on the surface.
4 It is very important to clean the patch glue in time. It can prevent the glue from flowing into the nail groove. If there is glue in the nail groove, it will not only make the customer feel uncomfortable, but also increase the chance of warping. Before attaching the nail piece to the nail surface, adjust the position and angle to accurately drop the nail piece with moderate force. Once it is applied, do not change the position. Wait until the glue is completely dry, about 15-20 seconds. There will be no bubbles.
5. The method of removing the marks of the shallow patch is to add a layer of crystal powder on the back edge of the nail, and then sand and polish.
