Nail stickers are a kind of convenient and practical nail products, it can save you time in the nail shop, and you can also get good-looking nail effects. However, there is often a problem when applying nail art stickers, that is, bubbles will appear. How to solve this problem?
1. Find the right nail piece
The curvature of the patch does not match the curvature of the natural nail, and the failure to fit the nail well is the main cause of blistering. The solution is very simple, which is to find a nail patch that suits you. It may take some time to find the process.
2. The angle of paste
When applying the nail art sticker, the nail piece is at a 45-degree angle to the nail. The groove on the inner side is first stuck at the front edge, and then lifts the front edge to squeeze the back edge a little bit. After the flow. Do not squeeze too much, because if the pressure is too high, the glue will be unevenly distributed between the nail piece and the nail cover.
3. Fill it with glue
If you really can't find a suitable nail piece, you can only fill it with glue. Apply glue to the nail in advance, the amount can be more, and then gently lift it at a 45-degree angle to control the flow of glue to the middle of the nail cover. Keep the pressure lower to ensure that the front edge of the natural nail to the middle part of the natural nail is covered with glue. Then gently lift it to the rear edge, and stay for a while to allow the glue to solidify. At this time, if there are still bubbles near the joint mark, you can use the method of glue repair.
